Manufacturers of products falling within the scope of Regulation (EU) 2023/1230 of the European Parliament and of the Council (24) which are also products with digital elements as defined in this Regulation should comply with both the essential cybersecurity requirements set out in this Regulation and the essential health and safety requirements set out in Regulation (EU) 2023/1230. The essential cybersecurity requirements set out in this Regulation and certain essential requirements set out in Regulation (EU) 2023/1230 might address similar cybersecurity risks. Therefore, the compliance with the essential cybersecurity requirements set out in this Regulation could facilitate the compliance with the essential requirements that also cover certain cybersecurity risks as set out in Regulation (EU) 2023/1230, and in particular those regarding the protection against corruption and safety and reliability of control systems set out in sections 1.1.9 and 1.2.1 of Annex III to that Regulation. Such synergies have to be demonstrated by the manufacturer, for instance by applying, where available, harmonised standards or other technical specifications covering relevant essential cybersecurity requirements following a risk assessment covering those cybersecurity risks. The manufacturer should also follow the applicable conformity assessment procedures set out in this Regulation and in Regulation (EU) 2023/1230. The Commission and the European standardisation organisations, in the preparatory work supporting the implementation of this Regulation and of Regulation (EU) 2023/1230 and the related standardisation processes, should promote consistency in how the cybersecurity risks are to be assessed and in how those risks are to be covered by harmonised standards with regard to the relevant essential requirements. In particular, the Commission and the European standardisation organisations should take into account this Regulation in the preparation and development of harmonised standards to facilitate the implementation of Regulation (EU) 2023/1230 as regards in particular the cybersecurity aspects related to the protection against corruption and safety and reliability of control systems set out in sections 1.1.9 and 1.2.1 of Annex III to that Regulation. The Commission should provide guidance to support manufacturers subject to this Regulation that are also subject to Regulation (EU) 2023/1230, in particular to facilitate the demonstration of compliance with relevant essential requirements set out in this Regulation and in Regulation (EU) 2023/1230.